Home > Knowledge > Seven kinds of bearing configurations

Knowledge

Seven kinds of bearing configurations

Date锛2013-09-10 9:28:57

Rolling widely used bearing types are varied, depending on the occasion, some forms bearing arrangement is not the same, so there will be about seven kinds of bearing configurations appear.
1. Install two pairs of side facing the end face of the bearing mounted on the same shaft installed one way, the work can be considered as a whole. Bearings can be back to back, face to face or in tandem installation.
2. Combination of three or more of the rolling bearing mounted side facing the end mounted on the same shaft installed one way, the work can be considered as a whole.
3. Two back to back configuration adjacent the outer ring rolling back on the back of the installation.
4. Configure two adjacent outer face of the front bearing to the front of the installation.
5. Two or more series arrangement of a rolling bearing in the lower back of the bearing outer ring of a bearing outer ring relative to the front of the installation.
6. Paired according to the given characteristic (usually I load or clearance) selecting two sets of rolling or manufactured in accordance with regulations ways to install together.
7. Group with three or more will be given according to the characteristics of rolling bearings, usually I pick load or clearance or manufactured in accordance with regulations ways to install together.

ONLINE MESSAGES

Your Name:
Telephone:
E-mail:
Message: